FailSafe Mode in Buffalo WZR-HP-G300NH2

Reading
Failsafe: http://wiki.openwrt.org/doc/howto/generic.failsafe

Note: There is a reset button at the bottom of the router. You can use a pen to prick that button.

Preparation:
1. Set your PC ip to 192.168.1.2. Netmask: 255.255.255.0 Gateway: 192.168.1.1 (plug in to LAN port)
2. Install telnet in your PC (if you don't have, try putty)
1. Remove the power cable.
2. Wait 30 secs and connect the power again.
3. When the red light in the front panel start to blink, prick the reset button
4. The red light will blink more faster, telnet in your router 192.168.1.1

root@openwrt:~# mount_root
root@openwrt:~# firstboot
root@openwrt:~# mtd -r erase rootfs_data

Comments

Popular Posts